Citizens Connected ADB 5721 Manual de usuario descargar pdf (Pagina 20)

www.urcsupport.com

4. Perform the instructions under

“Programming Device Control” on page 9 to

program device control for the desired cable

converter or satellite receiver.

When you are done, perform steps 5 and 6 on

this page to again lock the ID Lock.

PROGRAMMING MACRO KEYS

The Potenza ST Universal Remote Control includes two

macro keys (located directly below the MUTE and LAST

keys). Macro keys allow you to set up key macros to

activate certain keys in a specific order. For example, you

can set up a key macro to change the channels on your

TV, raise or lower the volume, and start recording on

your VCR, all with the touch of one key. If you want to

change the macros stored in a previously-programmed

macro key, you’ll need to clear the key first (see

“Clearing a Macro Key” on page 21).

Programming a Macro Key

3. Select a macro key (for example, F1) and

press it once.

5. On the remote control, press STB once; it will

blink once. Then press and hold SETUP until

the STB key blinks twice.

6. Enter 9 8 2. The STB key will blink twice,

indicating ID Lock is again locked.

1. On the remote control, press and hold SETUP

until it blinks twice.

2. Enter 9 9 5. The SETUP key blinks twice.

4. Press the key sequence you want to program

into the macro. For example, to turn on your

TV and raise its volume, press the TV mode

key once, followed by pressing the VOL+ key

once.

Nebula Potenza ST.fm Page 20 Monday, October 15, 2007 4:55 PM

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 59 60

Sin comentarios

Citizens Connected ADB 5721 Manual de usuario Pagina 20